How to Keep Ants and Wasps Off a Hummingbird Feeder

Ants and wasps are the two reasons a working feeder goes quiet in midsummer. Hummingbirds will not fight insects for a feeding port — they just leave. Both problems have cheap, permanent fixes.

Ants: use water, not poison

Ants come down the hanger. Put water in the way and the problem ends.

  1. Hang an ant moat — a small cup that sits between the hook and the feeder. Fill it with plain water. Ants will not cross it.
  2. Keep it topped up. A moat dries out in hot weather in a day or two, and a dry moat is just a decoration.
  3. Plain water only. Never oil, never insecticide, never petroleum jelly on the wire — anything greasy gets onto feathers, and a hummingbird cannot preen it out.

If your feeder has no moat, a small plastic cup with a hole in the bottom, threaded onto the wire and sealed with silicone, does the same job for almost nothing.

Wasps and bees: deny the sugar, do not kill the insect

Wasps cannot reach nectar that sits below a properly designed port. Most fixes are about the feeder, not the wasp.

  • Use a saucer-style feeder. The nectar sits lower than the port, out of reach of a wasp’s short tongue but easy for a hummingbird’s long one. This is the single most effective change.
  • Fit nectar guards — little plastic inserts that narrow the port. Cheap, and they work on most bottle feeders.
  • Fix every drip. A feeder that leaks, or one in full sun where the air inside expands and pushes nectar out, leaves a sticky trail that advertises itself. Move it into shade.
  • Clean the outside, not just the reservoir. Dried sugar on the body of the feeder keeps wasps interested after you have fixed everything else.
  • Move the feeder a few feet. Wasps navigate to a remembered location. Hummingbirds will find it again within a day; the wasps often will not.

What not to do

  • Do not spray insecticide near a feeder. You are poisoning the food supply of the bird you are trying to attract — and hummingbirds eat small insects constantly, not just nectar.
  • Do not grease the hanger. Oil, petroleum jelly and cooking spray all end up on feathers.
  • Do not weaken the nectar to make it less attractive to wasps. You make it less attractive to hummingbirds too. Stick to one part sugar to four parts water.
  • Do not hang a wasp trap next to the feeder. It concentrates wasps exactly where you do not want them.

The order to do it in

  1. Add an ant moat and fill it with water.
  2. Move the feeder out of full afternoon sun.
  3. Wash the outside of the feeder, not just the inside.
  4. If wasps persist, switch to a saucer-style feeder or fit nectar guards.
  5. If they still persist, move the feeder ten feet and wait two days.

While you are at it

Insects on the feeder often arrive alongside the other summer problem — nectar that has fermented in the heat. In hot weather, clean and refill at least twice a week; every other day is better.

Sources

  • Smithsonian’s National Zoo and Conservation Biology Institute — nectar recipe and cleaning frequency
  • Project FeederWatch, Cornell Lab of Ornithology — sugar water guidance

Last reviewed: October 2026.

Keep reading

Leave a Comment